3D five-axis laser cutting cell

ORBIT 5XFlagship

Bring the hard trims in-house. Take on formed parts.

Every machine runs for 72 hours, then cuts for 12, before it ships.

Cyclops ORBIT 5X 3d five-axis laser cutting cell

Axes: 5
Accuracy: ±0.03 mm
Turntable swap: 3 s
Max. speed: 140 m/min

Put ORBIT 5X to work

Take on the cuts a flat table cannot reach. ORBIT 5X trims formed and hot-stamped parts with five-axis motion. Load one side of the turntable while the other cuts, then swap stations in as little as 3 seconds.

Hot-stamped auto partsFormed sheet parts3D trimming

Gantry, double-side drive

Reach the next cut quickly

A stiff gantry driven from both sides helps the head move quickly into position.

Two-station turntable

Keep the next part ready

Load one station while the other cuts to reduce waiting between parts.

Full guarding

Keep the cutting area guarded

Door interlocks and light curtains guard the cell. A head collision guard helps protect the cutting head.

Check the specs

The numbers behind the work

Travel (L × W × H)	3100 × 2200 × 680 mm
Positioning accuracy	±0.03 mm
A axis	±135°
C axis	N × 360°
Max. running speed	100 m/min
Max. combined speed	140 m/min
Max. cutting speed	30 m/min
Max. acceleration	1 G
Turntable positioning	≤ ±15″, repeat ≤ ±10″

FAQ

Questions buyers ask

What parts can ORBIT 5X trim?+

ORBIT 5X is listed for hot-stamped auto parts, formed sheet parts and 3D trimming. Its travel is 3100 × 2200 × 680 mm. Five-axis motion helps reach cuts that a flat table cannot.

Can ORBIT 5X load a part while cutting another?+

ORBIT 5X uses a two-station turntable so one station can load while the other cuts. It lists a turntable swap of 3 seconds. Part loading and unloading time is separate from the swap.

What warranty applies to the ORBIT 5X laser?+

The laser warranty is 3 years above 12 kW and 2 years at 12 kW and below. ORBIT 5X does not list a power rating here. Confirm the selected laser power to determine the term.